Primer Beton is a single-component, powdered primer and adhesion promoter based on carbonate aggregates and quartz sands with controlled grain size, powdered polymer binders, specific additives, and short synthetic fibers. The simultaneous presence of mineral and polymer binders, inorganic fillers, and reinforcing fibers develops a positive synergy that increases the product's mechanical properties.

Smoothing and preparing interior and exterior walls and floors.

Smoothing directly on tiles, marble, cement-based plasters, mortar, etc.

Substrates must be dry, solid, and free of dust, paint, wax, oil, loose particles, and seasoned surfaces.

We recommend contacting our technical support team to ensure a perfect base before starting work.

Lay out the 70/80 g/m² fiberglass mesh, taking care to position it so that it does not crease, overlapping the ends of the mesh by at least 10 cm.

Pour about 6 liters of drinking water into a clean bucket and add the Primer Beton in small increments using a low-speed mechanical stirrer until the mix is ​​completely smooth.

Apply a single coat of Primer Beton using a stainless steel trowel, evenly and smoothly over the entire surface to be treated (in some cases, such as uneven floors, it is necessary to apply a second coat of Primer Beton as done with the first).

Let the product dry for 24 hours (+20°C).

Appearance: Powder;

Color: White;

Solid content: 100%;

Dilution: ~300 ml of potable water per kg of product;

Coverage: ±0.900 g/m² with a thickness of approximately 1.5 mm in a single layer;

Pot life: 3 hours at +20°C;

Grain size: Max. 0.5 mm;

Aggregate mineral nature: Silica/carbonate;

Consistency: Thixotropic;

Density of the mix: 1,500 kg/m³;

Packaging: 20 kg;

Storage: Store in the original, tightly closed packaging in a dry place between +10°C and +25°C;

UFI code: 0800-F0JY-8000-N9G7.

Operating temperature: +5°C to +35°C;

Recommended for use on interior and exterior walls and floors;

Apply to thoroughly clean and dry surfaces;

Properly cover fixtures, doors, etc.;

Do not apply to wet, frozen surfaces, or to repairs that are still damp;

Do not apply in strong sunlight, strong winds, or rain;

If surfaces are too hot due to the sun's rays, it is advisable to moisten them with water;

Store in a cool, dry place, away from direct sunlight;

Wait for the cement-based skim coat to cure before applying;

It is important that during application and for the following 24 hours, the temperature does not fall below +5°C and the relative humidity does not exceed 80%.

Compliant with the UNI EN 15457 standard (resistance to fungal growth), thanks to the presence of specific broad-spectrum additives, the product prevents the formation of mould, fungi, algae and moss over time.

The written and verbal technical and application instructions provided to buyers and installers are based on our experience and the current theoretical and practical state of the art. They are not binding and do not imply any contractual obligation or secondary commitment arising from the purchase contract. They do not exempt the buyer from personally verifying the suitability of our products for the intended application, at their own risk. The processing cycles indicated above do not constitute any assumption of liability by Nikkolor Italia s.r.l., which is exempt from any liability for problems arising from incorrect installation.