|
Intended use
Marblex Microresina is ideal for: coatings, bathrooms, furniture and furnishing accessories - for exteriors and interiors - environments for civil and commercial use - adheres to almost all surfaces such as glass, paper, wood - Knowledge of the products even if our application cycle does not require the use of a specific primer, it is also true that in front of types of substrates you need to have the best knowledge to be able to create a solid and effective structure that lasts over time. The Primer is the fundamental basis of the entire application process. |
|
Product
Marblex Microresina is a finish for floors and walls with a mirror effect with a smooth marble appearance for exteriors and interiors. It develops excellent adhesion qualities and remains unalterable over time in both colors and appearance. It develops excellent adhesion qualities and remains unalterable over time in both colors and appearance. It appears very pleasant, with a high aesthetic tone, recalling ancient prestigious finishes. It can be applied on any type of cement plaster, lime-based plasters, wooden panels, synthetic skims, gypsum and plasterboard. MARBLEX is an antiqued decorative finish obtained by using some of the finest raw materials that give excellent mechanical properties, remarkable chemical resistance, an effective obstacle to the formation of mold and bacteria, and in particular an extraordinary ability to oppose the spread of flames and to the development of fumes. |
|
|
Primer
Marblex Microresina can be applied on various substrates without the use of primers, for example substrates treated with well dry and anchored acrylic water-based paints, substrates previously treated with Cemento 3D, PanareaStone, or MarmUra (in this case the substrates will only serve the purpose of create new effects and new textures), in the case of old walls painted with old paints and without holes or cracks, apply a single coat of Primer Plus diluted 20% with drinking water. For application on new or existing floors, it is recommended to use the Beton KA + KB primer and the VL3D Liquid Glass finish. (Ask for info from our technical support). |
|
Application
Apply Marblex Microresina in two coats using a stainless steel trowel. After 8 hours from the application of the first coat, apply a second thin layer of the product, uniforming it until a flat and smooth surface is obtained and wait 8/12 for the product to dry in depth. |
|
|
Polishing
After drying, proceed with polishing the treated surface using polishing discs in silicon carbide of grain 1000 and 3000 using an electric polisher connected to a vacuum cleaner, after polishing it is advisable to wipe with a soft cloth to remove any traces of dust, it is possible to apply Marblex Medium-thick or multi-colored single-layer micro-resin. |
|
Transparent finish
ProteKto EcoSilan is an ecological colorless finish composed of a chain of silicon atoms and nano particles and a blend of silanes and siloxanes in aqueous emulsion, it penetrates deep into the capillaries of the support making it hydrophobic and at the same time breathable, non-film-forming with permanent action , resistant to UV rays, does not yellow in any environmental and aging conditions, it leaves the surfaces treated in a natural way. Rules of use and recommendations ProteKto EcoSilan is ready for use and must be applied using one of the following tools; brush, mohair roller, manual or airless spray. Application The surfaces in Marblex Microresina must be dry, apply a single layer of ProteKto EcoSilan and wait about 15/20 minutes, eliminate traces of excess product using absorbent paper, immediately after wiping a soft cotton cloth over the entire surface and leave to dry for at least 3/4 days, maximum resistance to water repellency is obtained after about 7/10 days. |
|
|
|
|
|
ATTACHED DOCUMENTATION
|
| ||||
|
| ||||
